Reasons for the reduction of the displacement of the screw air compressor
Air compressor selection is too small
Many users do not know the specific gas conditions they produce at the beginning, and they are about the type selection. At this time, the exhaust pressure does not come up, and the rated exhaust pressure is lower than the rated exhaust gas. At this time, you can check if there is a leak point in the pipeline.
Close the valve behind the gas tank. If the unit can quickly raise the pressure, open the valve, the pressure will drop quickly, and finally at a pressure point. This confirms that the air compressor unit is too small, the unit row The gas volume is less than the actual gas consumption produced.
Solution: Add a new unit, so that the air compressor is more scientific than the gas consumption of 10% to 20%.
Whether to add gas equipment
After using the air compressor for a period of time, the air volume is obviously insufficient, and the pressure cannot be maintained, and it is maintained at the lower line position of the rated gas. At this time, you should first check whether there is any new gas equipment. If there is new gas equipment, what is the gas consumption? Compare the air compressor unit to see if it can meet the requirements. If not, please put in new air pressure. The unit increases the displacement.
If there is no new gas equipment, the exhaust volume is still not enough. First check the leak of the pipeline. If there is no leak point in the pipeline, it is the problem of the air compressor unit itself.
Air compressor unit's own exhaust
The air compressor unit itself has insufficient exhaust capacity and has the following problems:
1. Is the maintenance timely?
The air pressure is reduced. After the above possibility is removed, first check whether the air compressor has been maintained and how long it has been maintained. If the environment is not ideal, the air compressor should be inspected for 2,000 hours after the air compressor is running. If it is light, the compressed air can be used. Dust removal, severe blockage, replacement of new air filter.
Many times, the air compressor exhaust volume drops, there is no big problem, that is, neglect maintenance, air compressor air filter blockage, replace the new air filter, normal use.
In addition, in addition to air filtration, lubricating fluids and other filter elements are also critical. Check if the lubricating fluid is within the standard range. If it is missing, please add it as appropriate.
2. Are the intake valves all open?
The air compressor has a reduced exhaust volume, check the unit, just maintain, and eliminate the three filters and oil problems. This is to first check the air compressor intake valve, remove the intake hose, open the air compressor, and watch the intake valve. Whether the opening degree is normal.
The theoretical design life of the intake valve is 100,000 times. Because each manufacturer uses different brand batches, the quality is also different. Therefore, the failure of the intake valve may cause the unit to reduce the exhaust volume.
If the intake valve cannot be fully opened when the air compressor is loaded, it can be concluded that the exhaust gas volume is a failure of the intake valve and should be removed for repair or replacement.
3, motor failure
After the above intake valve failure is eliminated, the displacement of the unit remains unchanged. The motor should be considered to be faulty. Due to a partial short circuit in the motor coil or wear of the bearing, the motor speed is lower than the rated speed, so that the air compressor discharge When it is lowered, the motor coil, bearing, etc. should be inspected, and the air compressor exhaust volume should be tested after repair.
4, the environment changes, resulting in a decrease in exhaust volume
As the altitude rises and the environment becomes damp, the unit's exhaust volume may drop. The higher the altitude, the thinner the air is, the smaller the gas production per unit time is, the excess moisture in the air, the compressed air contains a lot of water, and in the latter treatment, the water vapor is precipitated, resulting in a decrease in the exhaust gas volume.




