Screw air compressor preventive maintenance
The preventive maintenance we are talking about is to maintain the equipment on time according to the maintenance cycle; to reduce the occurrence of accidental faults; to check the equipment during the maintenance process to eliminate the hidden troubles; this is to prevent accidental faults, so that the equipment is always in Optimal operating condition
1. Check the power supply, motor temperature, check that the oil level gauge pointer should be in the upper part of the green area or in the orange area. If the pointer is in the red area, the oil level is low. Loosen the fuel plug one turn to allow the oil system to relieve pressure. Unscrew the filler plug and refuel until the oil level reaches the oiler. Install and tighten the filler plug.
2. Check the display readings:
A. Usually, the display shows the air compressor outlet pressure, the running status and the function key abbreviation displayed at the bottom of the display;
B. If the alarm indicator is on or flashing, the fault must be eliminated;
C. If a maintenance plan period exceeds or the maintenance period of a consumable part exceeds, the display will display the maintenance information. Perform maintenance measures in the maintenance plan or replace the consumables while resetting the relevant clock.
3. Check for condensate drain during loading. If the displacement is too small or there is no condensate discharge, it must be shut down for cleaning.
Water separator
4. Check the air filter service indicator: If the red part of the air filter service indicator is fully displayed, replace the air filter element and, if necessary, remove the dust from the air filter's dust collector. Press the setting button at the end of the filter to reset and reset the maintenance clock in the computer.
