May 19, 2017 Leave a message

Screw air compressor cleaning and maintenance --2. Air dryer cleaning

2. Air dryer cleaning


A: Air dryer --air cooled


 open the wind shield, clean the cover plate, or remove the cooling fan;

(2) blow down the dirt with compressed air, and then remove the dirt from the air guide; if it is dirty, spray some oil removing agent and blow it again. When the screw air compressor can not be cleaned by using the above method, it is necessary to remove the cooler, soak or spurt it with the cleaning liquid, and clean with a brush (forbidden to use wire brush).

(3) install a cover plate or a cooling fan


B: Air dryer--water cooled


Disconnect the cooling water inlet and outlet pipe.

Soak in a cleaning solution or cycle with a pump (better recoil).

Rinse with clean water.

Install cooling water inlet and outlet pipe.

When the oil cooler is seriously fouling, the oil cooler can be removed separately, the two end caps can be opened separately, and the scale can be removed by special cleaning steel brush or other tools. When cleaning the cooler medium side can not effectively reduce the temperature, the screw compressor needs to clean the oil side, the method is as follows:

Disconnect the inlet and outlet pipe;

Soak in a cleaning solution or cycle with a pump (better recoil);

Rinse with clean water;

Dry with dry air or remove water with dehydrating oil;

Install inlet and outlet pipe.


Send Inquiry

whatsapp

skype

E-mail

Inquiry