The outlet pipe of the screw air compressor is provided with a check valve, and the humid air at high temperature and high pressure is discharged through a screw air compressor exhaust valve, and a certain amount of oil and water is still entrained after the second stage cooler. Although the two or three stage intercooler and final cooler of screw air compressor are equipped with gas water separator, they are used to separate the moisture produced during the compression process, but the actual operation effect is not satisfactory. Because the screw air compressor stop preparation time, exhaust gas produced water gathered in the pipeline and valve around, to cause the water back to the inside of the case, the lubricating oil water content gradually increased, resulting in high pressure screw air compressor oil level alarm and shutdown. When the screw outlet of the screw compressor is removed, it is found that a large amount of milky liquid is flowing out, which indicates that the exhaust water content of the screw compressor is seriously over standard.
According to the operation requirements of the screw air compressor, the screw air compressor should be equipped with the minimum running time to prevent the formation of condensed water, because condensate water will cause the rust of the cylinder, valve plate, frame parts and so on. Accumulation of condensed water in the crankcase may cause an error in the oil level reading. Water and oil do not mix, and their common presence causes oil to deteriorate rapidly. The minimum operating time shall be no less than 10min, and shall be sufficient to heat the screw air compressor to the moisture of the gasification and condensation.
螺杆空压机的出口管路设有止回阀,高温高压的湿空气通过螺杆空压机排气阀排出,经过后级冷却器后仍夹带一定的油、水成分。虽然螺杆空压机的二、三级级间冷却器和末级冷却器后均配有气水分离器,用于分离压缩过程中产生的水分,但实际的运行效果并不理想。由于螺杆空压机停备时间长,排气产生的水分聚集在管路及止回阀周围,导致水分回流至机箱内部,润滑油含水量逐渐增多,最终导致高压螺杆空压机油位报警并故障停机。在停机拆除螺杆空压机的出口管路时,发现管内有大量的乳白色液体流出,这说明螺杆空压机的排气含水量严重超标。
根据螺杆空压机的运行要求,螺杆空压机应设有最低运行时间,以防止形成冷凝水,因为冷凝水会引起气缸阀片、机架部件等的生锈。冷凝水在曲轴箱中的聚积可能会造成油位读数出错。水和油无法混合,它们的共同存在造成油快速变质。最低运行时间一般不少于10min,应足以使得螺杆空压机加热到气化凝结的潮气。




