Familiar with these, make your air compressor more energy efficient
Electricity should be said to be the maximum energy consumption for the current factory. The air compressor as a pneumatic equipment is also one of the general equipments for manufacturing. Doing a good job in energy-saving management of air compressors is one of the tasks to achieve energy saving in enterprises.
Today, Wanzlai Energy Saving Air Compressor summarizes six common paths for energy saving in air compressors, and hopes to help energy-consuming enterprises achieve the goal of saving electricity and reducing consumption.
1
Daily inspection and leakage
According to the calculation, a small hole of 1mm2, under the pressure of 7bar, the leakage is about 1.5L / S, check all the pipe network and gas points, especially joints, valves, etc., in time to deal with the leak point.
2
Pressure drop treatment
Set the pressure gauge to detect the pressure through the pipeline section, check the pressure drop of each section in detail, and check the maintenance of the problematic pipe network section in time. Generally, the outlet pressure of the air compressor is 7 bar to the gas point, the pressure drop cannot exceed 1 bar, and the strict pressure is not more than 10%, that is, 0.7 bar. The pressure drop of the cold-drying filter section is generally 0.2 bar. The factory arranges the ring-shaped pipe network as much as possible. Balance the gas pressure at each point.
3
Adjust gas equipment pressure matching
We need to assess the pressure requirements of the gas equipment and try to reduce the compressor pressure in the air compressor as much as possible. The air compressor discharge pressure is reduced by 1 bar, and the energy saving is about 7~10%.
4
Adjusting irrational gas behavior
According to the statistics of the US Department of Energy, when the compressor is in operation, the electrical energy actually used to increase the potential energy of the air accounts for only a small part of the total power consumption. About 85% of the electrical energy is converted into heat energy, which needs to be used for the factory. Pneumatic equipment is evaluated and can be solved by electric means. At the same time, we should resolutely put an end to the routine cleaning work with compressed air.
5
Collective mode
If the number of air compressors is small, a variable frequency air compressor can be used for pressure regulation. If the number is large, centralized linkage control can be adopted to avoid the stepped exhaust pressure rise caused by the setting of multiple air compressor parameters.
6
Do a good job in equipment maintenance, cleaning, waste heat recovery, system transformation
Increase the cooling effect of the air compressor, the exchange effect of heat exchangers such as water cooling and air cooling, maintain the oil quality; recover the “excess” heat of the air compressor oil or gas for other processes or auxiliary living facilities; the new drying equipment utilizes air compressor The high-temperature exhaust heat is used to dry and dehydrate the compressed air, and the energy saving rate exceeds 80%.




