1.As time increases, the surface of the ABS probe will be dirty
Although the surface of the ABS sensor probe is almost entirely covered by metal, it is a rather delicate thing when actually used. Because of its position close to the bearing, it takes a long time to be easily stained or even rusted by various kinds of dust and grease in the bearing, so that it is filled with dirt between the hub and the ring gear, which affects the magnetic induction detection effect.
2.Dirty probes are no longer visible
Many ABS sensor failure cases are caused by excessive application of the bearing butter. Excessive butter can easily be squeezed onto the probe when the wheel is installed. Lightly affects the sensitivity of the ABS probe, but directly causes the probe to not sense the ring gear, causing the ABS system to malfunction.
3.After cleaning, use butter evenly to prevent rust from damming inside the bushing bracket.
The prevention and treatment of this kind of situation is very simple, that is, the bearing should not be too much when applying butter, the right amount. When cleaning, just remove the probe from the bracket, thoroughly clean it, and then evenly apply a layer of butter between it and the bushing to prevent rust in the bracket.
